What are the recommended cutting speeds for deep hole drilling inserts

Deep hole drilling is a process that requires precision and accuracy to ensure that the final product is of the highest quality. As such, it’s important to know the recommended cutting Carbide Grooving Inserts speeds for deep hole drilling inserts.

When drilling deep holes, the cutting speed should be kept between 45 to 90 meters per minute. The cutting speed should also be adjusted based on the particular material being drilled. Soft materials require lower cutting speeds while hard materials require higher speeds. The type of drill bit should also be taken into consideration when setting the cutting speed. Generally, slower speeds are preferred for larger drill bits while faster speeds are more suitable for smaller ones.

The feed rate should be adjusted in accordance with the cutting speed. If the cutting speed is set too low, the feed rate should be increased. Too high of a feed rate can lead to premature wear of the cutting edge and poor quality in the final product. The feed rate should be adjusted accordingly based on the material Carbide Insert for Cast Iron being drilled.

The depth of cut should also be taken into account when setting the cutting speed. For deep hole drilling, the depth of cut should be set to three times the diameter of the drill bit. Too low a depth of cut can cause an uneven surface finish while too high a depth of cut can lead to over-cutting.

Overall, when performing deep hole drilling, it is important to be aware of the recommended cutting speeds for the particular inserts being used. Choosing the right cutting speed, feed rate, and depth of cut can ensure that the final product is of the highest quality.

The carbide insert canada Blog: https://lorindunca.exblog.jp/